Step 1: Download the Headboard Dimension Diagram to determine the width of the headboard you’ll make. Then have a Lowe’s store associate cut a medium-density fiberboard (MDF) panel to the width of the headboard and 49-inches tall.
Step 2: Draw a centerline dividing the panel vertically. From the bottom, measure the distance shown on the Headboard Dimension Diagram and mark the centerline where you’ll anchor one end of a compass and trace the rounded top. Then lay out the 4-inch notches on both sides.
Good to Know: To make your own beam compass, duct tape a pencil to one end of a yardstick with the point about 1/2 an inch past the edge. Measure the distance from the pencil and tape a nail or scratch awl where needed along the yardstick. Add tape until there’s no movement of the pencil and nail or awl.
Step 3: Using a jigsaw with a fine-tooth blade, cut out the notches and arch along the line. Sand the cuts using 120-grit sandpaper.
Step 4: Mix equal amounts of wood glue and water to make glue sizing that will keep the paint from sinking into the porous MDF. Along the MDF edges, brush on a generous coat of sizing to seal them. When dry, smooth the edges with 120-grit sandpaper. Then apply two coats of primer to the MDF and sand smooth after each coat.
Step 5: Cut three 49-inch strips of wallpaper (two for the twin headboard) and place them vertically edge to edge on the headboard. Center the pattern and mark the headboard at the seam. Then moisten and apply each strip of wallpaper with a wallpaper brush and let dry.
Step 6: Trim off the excess wallpaper with a utility or crafts knife. If you want the headboard edges to contrast with the front, apply two coats of paint to the edges and let dry overnight. Then tape the edges and apply two coats of paint to the front.
Step 7: On the back side, draw a horizontal line 33 inches from the bottom. For a twin headboard, attach one centered Hangman bracket. For the other sizes, install two Hangman brackets with the ends 6-inches from the headboard edges. Attach the other half of each bracket to the wall where you’ll install the headboard—leave a 1-inch gap between the headboard and floor—and hang it in place. RE
This article is excerpted from Lowe’s Creative Ideas magazine. For more information, please visit www.lowes.com.
Copyright© 2013 RISMedia, The Leader in Real Estate Information Systems and Real Estate News. All Rights Reserved. This material may not be republished without permission from RISMedia.
Content on this website is copyrighted and may not be redistributed without express written permission from RISMedia. Access to RISMedia archives and thousands of articles like this, as well as consumer real estate videos, are available through RISMedia's REsource Licensed Content Solutions. Offering the industry’s most comprehensive and affordable content packages. Click here to learn more! http://resource.rismedia.com